General usage for BH862

BH862 was designed to be used specifically with MH series tops, and its operang range is a bit higher than typical subwoofers.

Using the HPF listed on the Spec Sheet is recommended (65 Hz, 24 dB/octave).

It’s also recommended to cross over with MH at a higher frequency than typical subs. (For example, the recommended sengs for MH662e, when used with BV535, show HPF/LPF filters @ 250 Hz.)

This is a good starng point, and adjust if needed for BH862.

Generally speaking, the BH862 LPF can be implemented at a higher frequency than a typical subwoofer, and the HPF for MH series should also be higher than a typical, full-range top.